Blog - The Vine Grace Coach

Lee Stone Lee Stone

0 Course Enrolled • 0 Course Completed

Biography

완벽한NSE7_EFW-7.2인증자료시험패스의강력한무기

안심하시고Itexamdump 를 선택하게 하기 위하여, Itexamdump에서는 이미Fortinet NSE7_EFW-7.2인증시험의 일부 문제와 답을 사이트에 올려놨으니 체험해보실 수 있습니다. 그러면 저희한테 신뢰가 갈 것이며 또 망설임 없이 선택하게 될 것입니다. 저희 덤프로 여러분은 한번에 시험을 패스할 수 있으며 또 개인시간도 절약하고 무엇보다도 금전상으로 절약이 제일 크다고 봅니다. Itexamdump는 여러분들한테 최고의Fortinet NSE7_EFW-7.2문제와 답을 제공함으로 100%로의 보장 도를 자랑합니다, 여러분은Fortinet NSE7_EFW-7.2인증시험의 패스로 IT업계여서도 또 직장에서도 한층 업그레이드되실 수 있습니다. 여러분의 미래는 더욱더 아름다울 것입니다.

인재도 많고 경쟁도 많은 이 사회에, 업계인재들은 인기가 아주 많습니다.하지만 팽팽한 경쟁률도 무시할 수 없습니다.많은 Fortinet인재들도 어려운 인증시험을 패스하여 자기만의 자리를 지키고 있습니다.우리Itexamdump에서는 마침 전문적으로 이러한 Fortinet인사들에게 편리하게 시험을 NSE7_EFW-7.2패스할수 있도록 유용한 자료들을 제공하고 있습니다.

>> NSE7_EFW-7.2인증자료 <<

Fortinet NSE7_EFW-7.2최신버전 덤프샘플 다운, NSE7_EFW-7.2합격보장 가능 시험대비자료

Fortinet NSE7_EFW-7.2인증시험은 전문적인 관련지식을 테스트하는 인증시험입니다. Itexamdump는 여러분이Fortinet NSE7_EFW-7.2인증시험을 통과할 수 잇도록 도와주는 사이트입니다. 많은 분들이 많은 시간과 돈을 들여 혹은 여러 학원 등을 다니면서Fortinet NSE7_EFW-7.2인증시험패스에 노력을 다합니다. 하지만 우리Itexamdump에서는 20시간 좌우만 투자하면 무조건Fortinet NSE7_EFW-7.2시험을 패스할 수 있도록 도와드립니다.

Fortinet NSE7_EFW-7.2 시험요강:

주제
소개

주제 1

Security profiles: Using FortiManager as a local FortiGuard server is discussed in this topic. Moreover, it delves into configuring web filtering, application control, and the intrusion prevention system (IPS) in an enterprise network.

주제 2

VPN: Implementing IPsec VPN IKE version 2 is discussed in this topic. Additionally, it delves into implementing auto-discovery VPN (ADVPN) to enable on-demand VPN tunnels between sites.

주제 3

Central management: The topic of Central management covers implementing central management.

주제 4

System configuration: This topic discusses Fortinet Security Fabric and hardware acceleration. Furthermore, it delves into configuring various operation modes for an HA cluster.

주제 5

Routing: It covers implementing OSPF to route enterprise traffic and Border Gateway Protocol (BGP) to route enterprise traffic.

최신 NSE 7 Network Security Architect NSE7_EFW-7.2 무료샘플문제 (Q29-Q34):

질문 # 29
Refer to the exhibit, which contains information about an IPsec VPN tunnel.

What two conclusions can you draw from the command output? (Choose two.)

A. The IKE version is 2
B. Both IPsec SAs are loaded on the kernel
C. Forward error correction in phase 2 is set to enable
D. Dead peer detection is set to enable

정답：A,B

설명：
From the command output shown in the exhibit:
B) The IKE version is 2: This can be deduced from the presence of 'ver=2' in the output, which indicates that IKEv2 is being used.
C) Both IPsec SAs are loaded on the kernel: This is indicated by the line 'npu flags=0x0/0', suggesting that no offload to NPU is occurring, and hence, both Security Associations are loaded onto the kernel for processing.
Fortinet documentation specifies that the version of IKE (Internet Key Exchange) used and the loading of IPsec Security Associations can be verified through the diagnostic commands related to VPN tunnels.

질문 # 30
You want to configure faster failure detection for BGP.
Which parameter should you enable on both connected FortiGate devices?

A. Distribute-list-in
B. Graceful-restart
C. Ebgp-enforce-multihop
D. bfd

정답：D

설명：
BFD (Bidirectional Forwarding Detection) is a protocol that provides fast failure detection for BGP by sending periodic messages to verify the connectivity between two peers. BFD can be enabled on both connected FortiGate devices by using the command set bfd enable under the BGP configuration.

질문 # 31
Refer to the exhibit, which shows two configured FortiGate devices and peering over FGSP.

The main link directly connects the two FortiGate devices and is configured using the set session-syn-dev <interface> command.
What is the primary reason to configure the main link?

A. To have only configuration synchronization in layer 3
B. To load balance both sessions and configuration synchronization between layer 2 and 3
C. To have both sessions and configuration synchronization in layer 3
D. To have both sessions and configuration synchronization in layer 2

정답：C

설명：
The primary purpose of configuring a main link between the devices is to synchronize session information so that if one unit fails, the other can continue processing traffic without dropping active sessions.
A:To have both sessions and configuration synchronization in layer 2.This is incorrect because FGSP is used for session synchronization, not configuration synchronization.
B:To load balance both sessions and configuration synchronization between layer 2 and 3.FGSP does not perform load balancing and is not used for configuration synchronization.
C:To have only configuration synchronization in layer 3.The main link is not used solely for configuration synchronization.
D:To have both sessions and configuration synchronization in layer 3.The main link in an FGSP setup is indeed used to synchronize session information across the devices, and it operates at layer 3 since it uses IP addresses to establish the peering.

질문 # 32
Refer to the exhibit, which shows a routing table.

What two options can you configure in OSPF to block the advertisement of the 10.1.10.0 prefix?
(Choose two.)

A. Configure a distribute-list-out
B. Disable Redistribute Connected
C. Configure a route-map out
D. Remove the 10.1.10.0 prefix from the OSPF network

정답：B,D

설명：
On OSFP distribute-list and route-maps exist only incoming, and because you want to exclude a connected network from redistribution you can not use the option "redistibute connected", so you have to specify the networks manually.

질문 # 33
Examine the IPsec configuration shown in the exhibit; then answer the question below.

An administrator wants to monitor the VPN by enable the IKE real time debug using these commands:
diagnose vpn ike log-filter src-addr4 10.0.10.1
diagnose debug application ike -1
diagnose debug enable
The VPN is currently up, there is no traffic crossing the tunnel and DPD packets are being interchanged between both Ipsec gateways. However, the IKE rea time debug does NOT show any output. Why isn't there any output?

A. The log-filter setting is set incorrectly. The VPN's traffic does not match this filter.
B. The IKE real time debug shows error messages only. If it does not provide any output, it indicates that the tunnel is operating normally.
C. The IKE real time debug shows the phases 1 and 2 negotiations only. It does not show any more output once the tunnel is up.
D. The IKF real time debug shows the phase 1 negotiation only. For information after that, the administrator must use the IPsec real time debug instead: diagnose debug application ipsec -1

정답：A

설명：
The most common filter option is dst-addr4, which you use to filter the output by the IP address of the remote peer.

질문 # 34
......

Itexamdump의Fortinet인증 NSE7_EFW-7.2덤프는 인터넷에서 검색되는Fortinet인증 NSE7_EFW-7.2시험공부자료중 가장 출중한 시험준비 자료입니다. Fortinet인증 NSE7_EFW-7.2덤프를 공부하면 시험패스는 물론이고 IT지식을 더 많이 쌓을수 있어 일거량득입니다.자격증을 취득하여 자신있게 승진하여 연봉협상하세요.

NSE7_EFW-7.2최신버전 덤프샘플 다운: https://www.itexamdump.com/NSE7_EFW-7.2.html